Sometimes during house projects, unexpected problems arise that have to be dealt with.
Okay, who am I kidding? That’s basically what’s happened to every house project since the beginning of time (any one who has remodeled knows this!). So…maybe cavemen didn’t stand there cursing their caveman contractor or the idiot who put the handprints on the wrong wall, but you get the idea.
As you may know, we’ve been working on increasing our curb appeal over the past few weeks. (Read about it here and here). We thought we’d take off the glass door, slap some paint on the one behind, swap out some fixtures and BAM! Dun-zo.
But of course, that was not to be the case. After removing the storm door, we found the wood trim had cracked and rotted. It was also ridiculously thick, so that without the storm door our front door looked like it was set back a good 8″. And that’s how we came to learn how to install exterior trim, and why I’m sharing this tutorial with you today.
The silver lining? We mastered a new skill, and our front door looks a-mazing:
- X-acto knife
- Small crowbar
- PVC brick molding door kit
- Construction adhesive (make sure it’s PVC- & exterior-appropriate)
- #6 galvanized finishing nails (galvanized= resists rust)
- Miter saw (We didn’t have this and improvised. This is what you’re supposed to use…)
- Measuring tape
- Exterior paint
If you have a storm door, remove it. Either way, you’ll probably need the X-acto knife to cut through and scrape off any existing caulk on the old trim.
Once the old trim has been cut free from the house, use the crowbar and/or hammer to pry it off. I was fortunate that my future in-laws were visiting that weekend, and Austin’s dad loves a good project!
The nice thing about brick molding door kits is that the head casing (that’s the top piece) comes pre-mitered. So, just apply liquid nails to the frame…
And press down the head casing, making sure it’s centered. Hammer 3-4 finishing nails, taking care to sink them.
Next you’ll need to measure the length of the side casings, from the outermost corner of the head casing. Don’t assume the left casing measurement is equal to the right though — measure both! Mark these measurements on the two leftover PVC lengths from the kit.
Set the miter saw to 45 degrees right for the right casing, and 45 degrees left for the left casing. Cut the mitered edge first, then re-measure the correct length, and finally make a 90-degree cut at the other end.
The next steps are the same as they were for the head casing. Apply the construction adhesive, hold the side casing in place, and hammer in finishing nails every 6-8 inches or so, and sink them with the hammer and another nail.
Fill the nail holes with caulk and wipe with a damp paper towel. Then, caulk the new trim to the house and door jamb, and fill the mitered edges. Wipe for a smooth, clean finish. Allow the caulk to fully dry before painting the trim.
What an improvement! You can see a few more updates we managed to make before winter reared its ugly head again, like that killer $17 light and those DIY house numbers (tutorial coming soon). We’re making progress, for sure, and I can’t wait to reveal the full curb appeal makeover next month!